Kohler 65EOZDJ Manuel d'instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Kohler 65EOZDJ. Kohler 65EOZDJ 16 pages. Sound shield kit gm86016-kp2 and ums sound shield kitgm88267-kp4
Imprimer la page
WARNING
Hazardous voltage.
Can cause severe injury or death.
Operate the generator set only when
all guards and electrical enclosures
are in place.
Short circuits.
Hazardous voltage/current can cause
severe injury or death. Short circuits can cause bodily injury
and/or equipment damage.
connections with tools or jewelry while making adjustments or
repairs. Remove all jewelry before servicing the equipment.
Installation Procedure
See Figure 18 for the installed kit illustrations. Refer to
the generator set operation or service manual for items
not shown.
Note: Apply pipe sealant to the male threads of all pipe
fittings before installation.
1.
Remove the generator set from service.
1.1
Press
the
generator
OFF/RESET button.
1.2
Disconnect the power to the battery charger, if
equipped.
1.3
Disconnect the generator set engine starting
battery, the negative (--) lead first.
Note: Before
installing
disconnect and route the battery leads
through the holes provided in the skid.
1.4
Remove the junction box panel(s) as needed to
access the wiring.
1.5
Remove the four controller panel screws.
Note: Clearly mark all disconnected leads from
the controller with tape to simplify
reconnection.
2
Moving parts.
Do not contact electrical
set
master
control
the
sound
shield,
1.6
Disconnect the following controller connectors.
See the corresponding wiring diagram found in
the operation manual for more details on wiring.
P1 (35-pin) connector
D
P2 (14-pin) connector
D
P3 (8-pin) connector
D
P4 Ethernet connector
D
Any other external leads to the controller.
D
1
2
1. P3 (8-pin) connector
2. P2 (14-pin) connector
3. P1 (35-pin) connector
4. P4 Ethernet connector
Figure 1 Decision-Makerr 3500 Controller
Connectors
1.7
Remove the controller. Save the hardware and
gasket to remount the controller into the sound
shield's controller panel later in step 12.1.
3
GM86969A-
4
TT-1602 5/16