Kohler DC2 Manuel d'installation - Page 31

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Kohler DC2. Kohler DC2 44 pages. Residential/commercial generator sets
Également pour Kohler DC2 : Manuel d'installation (48 pages), Fonctionnement (20 pages)

Imprimer la page

Use the following procedure to install and connect the

battery.

Battery Installation Procedure

1. Ensure that the starting battery is fully charged

before placing the battery in service.

2. Clean the battery posts and/or adapters if

necessary.

3. Install the battery post adapters, if needed.

4. Place the battery in the housing.

5. Connect the positive (+) lead to the engine starting

battery.

6. Connect the negative (--) lead to the engine starting

battery.

Refer to the generator set operation manual and the

battery

manufacturer's

maintenance instructions.

When power is applied to the RDC2/DC2 controller (that

is, when the battery is connected), you will be prompted

to set the date and time, and then to set the exerciser.

See Section 1.12 and the generator set operation

manual for instructions.

If the battery is disconnected for service or replacement,

the exercise settings on the RDC2/DC2 controller are

lost. Set the exerciser after installing and connecting the

battery. See Section 1.12, Set Exerciser.

1.10 Generator Set Accessories

Have accessories installed by an authorized distributor/

dealer or a licensed electrician. Follow the installation

instructions provided with each kit. Use separate conduit

for AC and DC leads to reduce the possibility of electrical

interference. Verify that the leads and conduit do not

interfere with the operation of the generator set or

obstruct the service areas. Verify that the electrical

installation complies with the National Electrical Code

(NEC) and all applicable local codes. See Section 2,

Wiring Diagrams, for more information regarding

generator set electrical connections.

TP-6803 12/11

instructions

for

battery

1.10.1 Regulator Heater

The regulator heater kit is designed for Model 20RESA

and 20RESAL generator sets. The regulator heater kit

is recommended in addition to the carburetor heater for

reliable engine starting in temperatures below --18_C

(0_F). See Figure 1-31 for heater specifications.

Regulator Heater

Heater rating

120 VAC, 60 W

Thermostat

C/13

Pad diameter

127 mm (5 in.)

Cord length

610 mm (24 in.)

Figure 1-31 Regulator Heater Specifications

The regulator heater requires a source of 120 VAC

power. The generator set is equipped with one 120 VAC

receptacle.

The kit includes an outlet splitter for

powering the regulator heater and an optional

carburetor heater. The circuit should be ground fault

protected.

To install the regulator heater kit, follow the instructions

in TT-1569, provided with the kit. Figure 1-32 shows the

installed regulator heater kit.

1. Regulator heater pad GM79142

2. Regulator mounting screws M933-06035-60, qty. 2

(re-use existing nuts)

3. Heater power cord

Figure 1-32 Installed Regulator Heater Kit

(for 20RESA/RESAL)

(

F/55

F) Snap action

GM79141

Section 1 Installation