AQC MAXIPLY DMP-170S Manuel du propriétaire - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} AQC MAXIPLY DMP-170S. AQC MAXIPLY DMP-170S 20 pages. Open type dust collector
Imprimer la pageMultiple pocket type dust collector
Follow rules and regulations regarding an open type dust collector installed within a facility.
Generally, such collector should comply with the following requirements is it is to be used for
collecting combustible dusts:
1. Must not be connected to a planer or sander with mechanical feed.
2. Must be installed 20' (6 meters) or more away from any work station, walkway or emergency
exit. If needed, a proper protective wall against blasts must be installed.
7
ASSEMBLY
7.1
Necessary tools
The following tools and equipment are recommended for the assembly of the dust collector :
•
Crane or fork lift
•
Swing jib
•
Chains
•
Shackles
•
Eye bolts
•
Tapered steel pins
•
Ratchet set
6. Lower the filter cabinet onto the dust storage section and align t
7. Attach the filter cabinet to the dust storage section using the su
washers and bolts. Tighten bolts for an adequate seal.
Figure 3
WORK SPACE ABOVE COLLECTOR
Support
plates
Support
legs
Cross braces
MAXITUBE
•
Spanners and/or wrenches
•
Power drill
•
Concrete drill bits
•
Concrete anchors
•
Nuts, washers and bolts
•
Self tapping crews
•
Silicone tubes
F
Unside bag
removal
7