A-TOUCH W-Thermo Manuel d'instruction - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} A-TOUCH W-Thermo. A-TOUCH W-Thermo 15 pages.

Imprimer la page

moment you change the temperature, then the new temperature is stored in all

active periods, regardless of if they were different or not.

To adjust the temperature, proceed as follows:

16:41

22º

21.2º

TEMP. 23º

16:41

23º

21.2º

16:42

22º

TEMP. 22º

16:42

22º

21.2º

VENTILATION SPEED

The unit types AIRFLOW2, AIRFLOW4, AIR-CON1, AIR-CON2 and DAIKINFD have

ventilation and their speed is controlled by the thermostat.

When you switch on the thermostat, the ventilation speed is always set to

automatic. In this mode, the ventilation speed depends on the difference between

the target temperature and the room temperature: the higher the difference, the

higher the ventilation speed.

You can choose a certain ventilation speed. However, if you do it then the speed

will remain as you specified, regardless of the difference between target and room

temperature (manual mode).

To change the ventilation speed proceed as follows:

22º

21.2º

22º

21.2º

Notes:

The AIRFLOW4 unit type only has 2 speeds, all others have 3 speeds.

The transition between one speed and the next has a pause of about 1

second. This is necessary to avoid relay damage in some kinds of

ventilators.

[email protected]

Press the key

(UP) to increase the temperature:

- the target temperature is shown temporarly on the big display and

then goes back to the normal display.

Press the key

(DOWN) if you want to decrease the temperature:

- the target temperature is shown temporarly on the big display and

then goes back to the normal display.

Press the key

(VENT) to select the next speed:

- the new speed is shown on the top left corner.