Aqua KID ECO P3 Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Aqua KID ECO P3. Aqua KID ECO P3 8 pages.

- Do not use in presence of water with unknown origin or microbiologically not pure, without providing

for the use of an adequate disinfection system;

- Use the filters in compliance with the operating pressures declared by the manufacturer. With

presence of high pressures in the circuit or "water hammer", protect the device by installing a

pressure reducer upstream;

- Except for special filters, use the filters with liquids at room temperature (20-25°C), however within

the limits indicated by the manufacturer. If used upstream of a boiler, it is recommended to install a

non-return valve to prevent boiling water from entering the filter;

- Do not use the containers for the filtration of compressed air, oil or gas, even at low pressures.

- Do not use these filters in environments exposed to freezing temperatures or high temperatures.

Therefore, installation outdoors or in places exposed to bad weather or ultraviolet rays is not

recommended;

- This equipment requires regular periodic maintenance in order to ensure the maintenance of the

drinking water requirements of the treated water.

INSTALLATION

The installation of the filter must be performed by qualified personnel capable of issuing a regular

declaration of conformity.

The typical filter assembly scheme is the

one shown in the image alongside.

It is advisable to create a bypass to

ensure maintenance of the filter cartridge

without eliminating the supply of water to

the users.

During the assembly phase it is important

to respect the inlet / outlet direction (IN-

OUT) indicated on the filter head. This is necessary to allow the cartridges to work correctly.

IMPORTANT: The AQUA KID filter head is equipped with a double inlet: one horizontal and one

vertical. Use the one that best suits the circuit and remember to put the appropriate cap in the unused

inlet.

To install the filter on the wall, use the appropriate wall bracket (optional), which allows for correct

fixing and proper spacing from the wall, necessary to ensure the opening of the filter with the use of

the appropriate key.