Aqua SPOT LED Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Aqua SPOT LED. Aqua SPOT LED 4 pages.

Start-up

• The lamp should only operate underwater while secured to the vertical walls of the pool. Never switch on

the lamp if it is not underwater.

• In case of colored lamps, 16 pre-programmed effects and combinations may be selected using the on/off

switch of your pool lights. Just switch off and switch on within 3 seconds.

• If the light is powered off for more than 20 seconds, it will keep the latest program when it is turned on

again.(Memory Function)

• To achieve synchronization, confirm all lamps are installed correctly on the same switch, after they are

powered off for more than 20 seconds, switch on and switch off continuously 3 times, and then finally

turn them on again. They will all go to program 1. Now you can select a program for them by switch off

and on within 3 seconds .(Re-set Function)

• White / blue lamps can work with white or blue light. To switch from one type to another use the on / off

button as for the RGB lamps.

Safety Warnings

• Don't use electronic transformers which may damage the light. You should use industrial

frequency transformer, such as toroidal transformer and square transformer .

For your security the persons who are in charge of installation should have the required qualifications for

this type of work.

• Avoid making contact with the electric voltage.

• Comply with the current standards regarding accident prevention.

• IEC 364-7-702 standards must be observed: SWIMMING POOLS.

• Replacement must be performed with the lamp disconnected from the electric power system.

• Do not handle any electrical components with wet feet.

Warranty

The manufacturer warrants this spot LED underwater against defects in materials and workmanship in

accordance with the document "General Terms and Conditions of sale" of AQUA spa.

This warranty does not cover the fixture becoming damaged due to misuse, accidental damaged, improper

handling and/or installation and specifically excludes liability for direct, incidental or consequential damages.

WARNING: Frequent voltage fluctuations can irreparably damage the lamp.

If the installation must take place in areas where these changes may be frequent, a system to protect the

lamps must be installed on the electric system of the pool.

The manufacturer does not guarantee lamps that have been damaged by these events.

However, faulty lamps with the following faults are not to be considered:

• Lamps with less than 500 LEDs: 3 LEDs off or less.

This defect is part of the normal operation of the lamp.

Relevant directives:

The unit meets the essential requirements of EC directives, it was also built in compliance with the WEEE

directives, and complies with the requirements of European Directive 2002/95/EC(RoHS).

End-of-life care for the electrical device:

The present product is subject to proper disposal at the time of its disposal.

Once discarded, it must be delivered to an appropriate collection point for the

recycling of electrical and electronic equipment.

For more detailed information about the recycling of this product, you can contact the

office of your municipality or the local waste disposal service.