Aqua Comfort Heat pump pool heater Manuel du propriétaire - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Aqua Comfort Heat pump pool heater. Aqua Comfort Heat pump pool heater 16 pages.
Imprimer la page
ELECTRICAL CONNECTIONS
• Field connections must comply with national and local codes. The work must be done by a qualified
ELECTRICAL CONNECTIONS
electrician.
Field connections must comply with national and local codes. The work must be done by
• Heater must be permanently grounded and bonded. Bonding will drastically reduce the chances of
a qualified electrician.
electrolysis, "Electrical Corrosion. "
Heater must be permanently grounded and bonded.
• Use copper conductors only.
Bonding will drastically reduce the chances of electrolysis, "Electrical Corrosion."
Use copper conductors only.
• Disconnect all power sources before performing any work on unit.
Disconnect all power sources before performing any work on unit.
• Standard Power Supply: 208/230 - 60 - 1
Standard Power Supply: 208/230 - 60 - 1
See unit data plate for specific ampacity.
• See unit data plate for specific ampacity.
Wiring Main Powe r Supply
WIRING MAIN POWER SUPPLY
1. Remove the screws from lower left and right side of front cover (service panel).
1. Remove the screws from lower left and right side of front cover (service panel).
2. Remove the screws on left side of hinged electrical enclosure.
3. Route weather tight, flexible conduit through opening at base of unit.
2. Remove the screws on left side of hinged electrical enclosure.
4. Connect conduit to bottom of the electrical enclosure using a weather tight fitting. A
3. Route weather tight, flexible conduit through opening at base of unit.
knockout is provided near the main contactor to accept the weather tight fitting.
4. Connect conduit to bottom of the electrical enclosure using a weather tight fitting. A knockout is
Mounting conduit directly to the electrical enclosure will ensure a moisture tight seal,
provided near the main contactor to accept the weather tight fitting. Mounting conduit directly to the
extending the life of the heater.
5. Attach grounding conductor to the ground lug provided inside the electrical enclosure
electrical enclosure will ensure a moisture tight seal, extending the life of the heater.
(labeled).
5. Attach grounding conductor to the ground lug provided inside the electrical enclosure (labeled).
6. Install L1 and L2 input conductors to the line side of the main contactor. (See wiring
diagrams.)
6. Install L1 and L2 input conductors to the line side of the main contactor. (See wiring diagrams.)
7. Connect bond wire (at least #8 solid copper wire) to bond lug provided on right or left
7. Connect bond wire (at least #8 solid copper wire) to bond lug provided on right or left side of coil
side of coil header plate to pool pump bonding terminal or other suitable location.
header plate to pool pump bonding terminal or other suitable location.
Notes
1. Use copper conductors only.
Notes
1. Use copper conductors only
2. Connect field wiring in grounded rain tight conduit, per rating plate.
2. Connect field wiring in grounded rain tight conduit, per rating plate.
3. Connect bond wire to pool steel using # 8 solid copper wire or larger.
3. Connect bond wire to pool steel using # 8 solid copper wire or larger.
4. All wiring must conform to National (N.E.C.) and local electrical codes.
4. All wiring must conform to National (N.E.C.) and local electrical codes.
...................................................................................................................................................................................................................
..........................................................................................................................................................
4
OWNER'S MANUAL
Field Wiring Diagram
6