Aqua Computer AQUASTREAM XT USB Manuel d'utilisation et d'installation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} Aqua Computer AQUASTREAM XT USB. Aqua Computer AQUASTREAM XT USB 20 pages.
Également pour Aqua Computer AQUASTREAM XT USB : Manuel d'utilisation et de fonctionnement (16 pages)

Imprimer la page

aqua

computer

AQUASTREAM XT

sources" tab in the chart configuration and select a data set to be exported. If no

data sources are available, you will have to configure the log settings as described

in the corresponding chapter of this manual. Select the time period to be exported

on the right side of the window and start the export process by clicking the "Export

data" button. Enter a file name and path in the following dialog window.

11.4. Automatic data export

The automatic data export feature can be used to save data from the aquasuite

into an XML file on the hard disk or in the RAM („memory mapped file") in a regu-

lar time interval. The automatic data export will always overwrite the previously

saved data, so the file always contains only the most recent data set. Select "Auto-

matic data export" below the "Data log" headline in the listing to access the set-

tings screen. Create a new export data set by clicking the plus symbol in the upper

right corner of the screen. Enter name, path and time interval to meet your re-

quirements. You may then add the data sources to log by clicking the plus symbol

in the "Data sources" window section. You may add an unlimited number of data

sources to each export data set, the total number of export data sets is also unlim-

ited.

12. Pump configuration (aquasuite)

Select "Pump" from the device list for the device to be configured.

12.1. Pump mode

In the upper area, current pump data (speed, voltage, current) is displayed as

plain text as well as in a diagram.

Select the desired mode of operation below the diagram. If "Automatic maximum

pump speed" is selected, the pump will automatically operate at the highest ap-

plicable speed. The pump controller constantly monitors rotor orientation, electric-

al current, power dissipation and supply voltage to calculate optimum rotation

speed. During power up, the pump may fall back to standard speed several times

until the highest (stable) operating speed is determined. Using standard water

cooling setups, this speed will normally be around 4000 – 5000 rpm depending

on the resistance of the system. The maximum speed can be limited by changing

the parameter "maximum pump speed".

If "Manual speed settings" is selected, you can set the rotation speed of the pump

manually. If the selected speed cannot be attained, the pump controller will use

the highest stable rotation speed (below the set speed) just like in automatic mode.

12.2. Power settings

In manual speed mode, set the desired pump speed.

Aqua Computer GmbH & Co. KG

- 15 -

Gelliehäuser Str. 1, 37130 Gleichen