AAVIX GC-1032 Manuel du propriétaire - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} AAVIX GC-1032. AAVIX GC-1032 15 pages.

Press NOTCH, then + or – to select the target to be notched.

The cursor above the selected target will flash. Press NOTCH

again, the target name below the cursor will disappear. It

means this target will be notched during the detection and the

detector will have no reaction to the notched target. If you want

to pick up the target notched, simply press NOTCH again.

Press + or -, the cursor will move from left and right. If NOTCH

is not pressed within about 3 seconds, the detector will enter

standby state.

Note:

1. It is not recommended to notch all targets listed on the

LCD. Because if you notch everything, you can't find

anything.

2. If you want to select the setting of DISC or SENS after

pressing NOTCH, you have to wait for about 3 seconds

until the cursor above the target goes out.

3. Press SENS then + or – to set the sensitivity. The default level is of

6 bars.

Note: If you don't press the buttons (SENS,+,-) within about 2

seconds, the detector will enter the standby state.

4. Place the detector on a wooden or plastic table, then remove any

watches, rings, or metal jewelry you are wearing.

5. Adjust the search coil so the flat part points towards the ceiling.

Note:

Never test the detector on a floor inside a building. Most buildings have

metal of some kind in the floor, which might interfere with the objects

you're testing or mask the signal completely.

Slowly sweep a sample of the material you want the detector to