AVLink DVI-ELW Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AVLink DVI-ELW. AVLink DVI-ELW 3 pages.

Imprimer la page
Installation
1. Turn off the PC and DVI monitor.
2. Connect the DVI extension cable between the PC and
the "DVI IN" port of DVI-ELW.
3. Connect the DVI extension cable between the DVI
monitor and the "DVI OUT" port of DVI-ERW.
4. Connect the CAT.5 cables between the DVI-ELW "LINK"
port and the DVI-ERW "LINK" port of extender.
5. Connect the power cord and turn on the extender.
6. Turn on the PC and DVI monitor.
IR Receiver Cable Directions:
Put it into the DVI-ERW "IR2 IN" port and place the IR
Receiver Cable, so that you can point to it easily with your
IR remote controller.
IR Blaster Cable Directions:
Plug IR blaster cable plug into DVI-ELW "IR OUT" port, it
sits in front of the
device
receiver's IR sensor, which is
located on the front-panel.
Additional Options
Select any additional options you may require.
1. IR Receiver Cable
GND
+V
Sig
2. IR Blaster Cable
NC
P+
N-
-3-
Technical Specifications Output Signal
Pin #
Signal
Pin #
1
T.M.D.S Data 2-
16
2
T.M.D.S Data 2+
17
3
18
T.M.D.S Data 2/4 Shield
4
T.M.D.S Data 4-
19
5
T.M.D.S Data 4+
20
6
DDC Clock
21
7
DDC Data
22
8
23
Analog Vert. Sync
9
T.M.D.S Data 1-
24
10
T.M.D.S Data 1+
11
T.M.D.S Data 1/3 Shield
C1
12
T.M.D.S Data 3-
C2
13
C3
T.M.D.S Data 3+
14
C4
+5V Power
15
GND
C5
Wiring Information & Coding
Conductor
RJ45 Pin
Identification
Assignment
5
Pair 1
4
1
Pair 2
2
3
Pair 3
6
7
Pair 4
8
-4-
Signal
Hot Plug Detect
T.M.D.S Data 0-
T.M.D.S Data 0+
T.M.D.S Data 0/5 Shield
T.M.D.S Data 5-
T.M.D.S Data 5+
T.M.D.S Clock Shield
T.M.D.S Clock+
T.M.D.S Clock-
Analog Red
Analog Green
Analog Blue
Analog Horz Sync
Analog Ground
Color Code for
Conductor
White-Blue
Blue
White-Orange
Orange
White-Green
Green
White-Brown
Brown
-5-