Aqua Cooler Cascade Series Manuel d'utilisation et d'entretien - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Aqua Cooler Cascade Series. Aqua Cooler Cascade Series 13 pages.
Imprimer la pageconverTing To mainS connecTed
Your cooler comes ready to use a 12 L to 19 L water bottle, or it can be used with a direct water line
connect and filtration system. If the inlet water pressure is above 690 kPa, a pressure regulator must be
installed in front of the unit's water inlet.
1.
Remove the bottle siphon from the door by pulling the handle away from the door. (See arrow in Fig.
A)
2.
Disconnect the (1) Bottle Siphon tube (1/4") and (2) Return tube (3/8") from the Bottle Siphon
assembly quick-connect fittings. (See Fig. A)
3.
Join both tubes together with the supplied quick-connect fitting. (See Fig. B)
4.
Store the siphon in a safe place for future use. The siphon assembly fits in the open space next to the
Fig. A
1
2
imporTanT noTe - Do not use water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
Water Tube Connection Procedure
Collet
Body
To connect, push tube through collet
ring into body.
Your Partner in Cool.
8
Fig. B
Bottle Siphon tube (1/4")
Return tube (3/8")
Tube must sit fully past o-ring.
Rear of cooler
Fig. C
water connection
to lter
outlet
remove tting
to lter inlet
for lter use
To disconnect, hold collet ring against
body and pull tube out.