Aqua Cooler BF200WSH Manuel d'utilisation et d'entretien - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Aqua Cooler BF200WSH. Aqua Cooler BF200WSH 5 pages.

Imprimer la page

INSTALLATION

1.
All UrbanFF Fountains must be installed by a qualified plumber in accordance with National plumbing and
drainage code AS/NZS 3500.1 and AS/NZS 3500.2 and any local authority codes.
2.
Before Installation FLUSH ALL EXTERNAL LINES before connecting to fountain.
3.
When mounting the fountain off a wall, check first with a Structural Engineer to ensure it has the capacity
to support this cantilevered fountain. Provide adequate surface for mounting fountain.
4.
Mark the mounting points for the fountain and dyna-bolt or chemset in place.
5.
Allow for water inlet as shown on Diagram A
6.
Remove the fountain from the packaging preventing scratching and damage.
7.
All fountains have been checked for leaks as part of our quality assurance program and some droplets of
water may be evident inside the packaging and/or unit. This is perfectly normal.
8.
Remove main access panel from fountain using 4mm allen key.
9.
Mount the fountain in place and tighten the bolts.
10.
If you have not flushed the external water inlet pipes – do it now! Flushing the water inlet pipes from the
mains supply before connecting to fountain will help prevent blockage by any debris that may be in the
external pipes.
11.
Connect water supply to 1/2" BSP inlet.
12.
Test the bubbler by activating the button.
13.
Refer to trouble shooting guide if you experience any problems.
14.
Check all connections to ensure they are tight & secure.
IMPORTANT
THIS UNIT MUST BE INSTALLED BY AN AUTHORISED PLUMBER
THE UNIT TO BE CONNECTED IN ACCORDANCE WITH
AS/NZS 3500.1 or AS/NZS 3500.2
Attention Plumbers:
• This fountain uses "Push In Fittings". Failure to release these fittings correctly will result in leakage.
• These quick release fittings allow instant connection and disconnection without the use of spanners.
Your Partner in Cool.
2

FEATURES AND SPECIFICATIONS

Specifications
•
1/2" bsb water inlet (15mm)
•
Maximum Temperature: 40 c
•
Maximum Water Pressure: 1000 kpa
•
Complies with WMTS-105 Technical Specification: Appliances - Beverage dispensers and icemakers
•
Complies with AS/NZS 4020 Testing of products in contact with drinking water
3