Dexter Laundry STACK DRYER Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dexter Laundry STACK DRYER. Dexter Laundry STACK DRYER 6 pages. Programming procedures and features

Imprimer la page

DESCRIPTION OF CONTROL

The single electronic control unit controls all coin counting, timing, temperature control and
displaying of information for both tumblers.
Each digital display shows vend price when its particular tumbler is waiting for coins to be
inserted. When a tumbler is in use, the display shows the number of minutes remaining to be
used on that tumbler.
The small green light to the left of the displays flashes to indicate that money has been added
to the coin acceptor. The flashing stops when the customer credits the coins to one tumbler or
the other by touching a start button or temperature selection button for the appropriate tumbler.
At this time the purchased time is reflected by the digital display.
The three temperature selection buttons for each tumbler also have indicator lights to indicate
which selection of temperature has been made. At the end of the cycle, the digital display
flashes until the operator opens the door to remove his load.
Temperature readout for each tumbler is available by pressing the temperature that is in use
along with the start button for that tumbler.

OPERATING INSTRUCTIONS

1. Load clothes into the tumbler and close the door.
2. Deposit the vend price that is shown in the display. Choose the desired temperature for the
tumbler to be used and then push the start button.
3. Additional time may be purchased and is added to the displayed time by touching the start
button or temperature selection button.
Characteristics of running dryer:
Temperature selection may be changed at any time with the dryer running.
Running time may be extended any time that time is showing on the display even if the added
amount is less than the original vend price.

PROGRAMMED DATA:

Adjustable parameters are vend price, temperatures, and cool-down times. Hours run and
money count information can be displayed and these registers are resettable to zero.
There are sixteen programming steps. These sixteen steps are: (all temperatures are degrees
Fahrenheit).
PROGRAMMING ORIGINAL
STEP DESCRIPTION
00
Lower drum hour meter
01
Upper drum hour meter
02
Left coin audit
03
Right coin audit
04
Hot temp. setting
05
Medium temp. setting
06
Warm temp. setting
07
Left coin input
08
Right coin input
09
Vend price
10
Time left coin
11
Time right coin
12
Time for free vend
13
Cool down time Hot cycle
14
Cool down time Medium
15
Cool down time Warm cycle
16
Temperature
RANGE
INCREMENTS
0 to 9999 hr.
—
0 to 9999 hr.
—
0 to $9999
—
0 to $9999
—
150-190
5
120-170
5
110-150
5
0-100
5 cents
0-100
5 cents
0-100
5 cents
0-99:55 minutes
5 sec.
0-99:55 minutes
5 sec.
0-99:55 minutes
5 sec.
0-10:00 minutes
5 sec.
0-10:00 minutes
5 sec.
0-10:00 minutes
5 sec.
Type display Centigrade or Fahrenheit
SETTINGS
0
0
0
0
175
150
125
.10
25
25
3.20
10:00
10:00
2:00
2:00
2:00
C or F