Aqua Creek F-700RL Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aqua Creek F-700RL. Aqua Creek F-700RL 14 pages.

Imprimer la page

LIFTING

ARM

1/2" X 3"

SHOULDER

BOLT

STEP 5: ADJUST THE SEAT POSITION

The SEAT ASSEMBLY will arrive attached to the SEAT ARM

adjusted to its highest position. To adjust the SEAT ASSEMBLY

to a lower position remove the hardware as shown below.

Slide the SEAT ASSEMBLY to its desired position (in 4 inch

increments) and reinstall the hardware. The maximum

adjustment is 16 inch (down).

DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS

– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE

SEAT ASSEMBLY TO THE CHAIR ARM!

NOTE: For most applications, such as pools with a flat deck,

the seat will be installed in its lowest position. For applications

where a wall or curb must be cleared the seat should be

installed in a higher position. In its highest position the seat

will clear a 30 inch [762mm] high wall.

5/16" NYLOCK

NUT

5/16" FLAT

WASHER

Revolution Assembly Instructions

CONTROL

ARM

3/8"

FLAT

NYLOCK

WASHER

*STANDARD SEAT-ARM

(OR SPA SEAT-ARM,

OR SLING SEAT-ARM)

*NOTE: FOR APPLICATIONS WHICH USE

MULTIPLE SEAT-ARMS, REMOVE NUTS &

BOLTS AND REPLACE ARM AS REQUIRED.

STEP 5

3/8" X 2"

SHOULDER BOLT

5/16" X 4-3/4"

HEX BOLT

5/16" FLAT

WASHER

STEP 4: INSTALL SEAT ARM

Locate the SEAT ARM and the following hardware:

STEP 4

• (2) 1/2" x 3" SHOULDER BOLT

• (2) 3/8" FLAT WASHER

• (2) 3/8" NYLOCK NUT

Install the SEAT ARM at the ends of the CONTROL

ARM and LIFTING ARM as shown in the figure to the

3/8"

left. Tighten the NYLOCK NUTS until snug as shown in

NUT

PHOTO 4. DO NOT OVERTIGHTEN!

(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM

THE MAIN ASSEMBLY)

NOTE: FOR APPLICATIONS THAT UTILIZE MULTIPLE

SEAT ARMS (SUCH AS FOR A SLING SEAT OR THE SPA

SEAT-ARM) USE THIS STEP TO REMOVE AND REPLACE

THE SEAT ARM.

SEAT-ARM

HOLES AT 4"

INTERVALS

ALLOW FOR

ADJUSTMENT

OVER 16"

SEAT ASSEMBLY

ADJUSTED TO

LOWEST POSITION

(SEAT WILL ARRIVE

AT HIGHEST

POSITION)

RANGE

Revised 8/11/16

MAIN

ASSEMBLY