Aqua Creek Products ACF-SCTXL Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aqua Creek Products ACF-SCTXL. Aqua Creek Products ACF-SCTXL 15 pages. Pool lift

Imprimer la page

Saw-cut Retro-fi t/New construction

Mask the bottom hole of the anchor sleeve to prevent concrete from seeping in.

Install rebar in the 3'-6" x 3'-6" section of the deck that will be thickened to 10". SEE

FIGURES B & C.

Set the bronze anchor sleeve in place. Make sure the center of the anchor sleeve

is no more than 44" from the pool's edge. Set the fi xing anchor insert 3 1/2" from the

center of the anchor sleeve. Fixing anchor may be located anywhere on the deck, as

long as it is 3 1/2" from the center of the anchor sleeve. SEE FIGURE B.

Bond the anchor sleeve according to your local code requirements by using the

bonding lug and bonding screw on the side of the anchor sleeve.

Pour your concrete and fi nish the pool deck surface.

Once the concrete has cured, your lift is ready to be mounted into the anchor sleeve.

21"

3'-6"

(MIN)

21"

3'-6" SQ. X 10" DEEP CONC. FTG.

W/ 4-#5 E.W., TOP & BOTT. (2500 PSI)

DRILL AND EPOXY REBAR TO EXISTING SLAB

(5" MIN. EMBED W/ HILTI RE500 SD OR SIMPSON SET-XP EPOXY)

IS RECOMMENDED TO RESIST DIFFERENTIAL MOVEMENTS

8-AWG SOLID COPPER WIRE

(TO BONDING GRID)

1" X 4" PVC FIXING ANCHOR

BONDING LUG: BOND PER LOCAL CODE

2.19

O.D. X 6" BRONZE ANCHOR ASSEMBLY

Anchor Installation:

3'-6"

12"

(MIN)

MIN

7" MIN

3 1/2"

(32" MAX)

POOL

WALL

BOND

BEAM

(E) SLAB

4" MIN.

FIGURE B

FIGURE C

Revised 4/20/20