Aqua Creek Products F-004PLB-XR Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aqua Creek Products F-004PLB-XR. Aqua Creek Products F-004PLB-XR 20 pages.

Imprimer la page

Required Tools:

Concrete saw with diamond blade

Tape measure

4' long straight edge or chalk line

Sledge hammer

Cold chisel

Torpedo level

String line

Concrete and concrete tools

#4 Rebar

FIGURE 5

1. Locate the anchor plate, three (3) anchor inserts with nuts and

Bonding Lug

mounting hardware). (If sold separately from lift, part number

F-910SAJP).

2. Mark out a section of the pool deck to be removed using a chalk

line or straight edge and a marker. Plan on removing at least a

3'-9" x 3'-9" x 6" section.

3. Using the saw with the diamond blade, make cuts along the

lines previously marked.

4. Using the sledge hammer, break up the concrete within the area

cut and remove the pieces.

5. After the portion of the deck has been removed, verify the new

deck will be able to be at least 6 inches deep.

6. Remove ONE of the nuts from each of the anchor inserts and

place the anchor inserts through the larger holes in the anchor

plate. Thread the nut back on the other side of the anchor insert

so the anchor plate is sandwiched between the nuts. (See FIG 5).

7. Install rebar in the open area of the deck. Tie the rebar into the

existing deck if possible.

8. Set the anchor system in place making sure the center line of the

anchor inserts are no more than 38 inches away from the pool's

edge.

9. Use the string line or a straight edge to make sure the top of

each anchor bolt is level and ush with the FINISHED deck

surface. Each anchor bolt can be adjusted individually by

turning the nuts with a large wrench.

10. Bond the anchor system using the bonding lug on the anchor

jig-plate. The anchor should be bonded to the pool's bonding-

grid according to local code requirements. (Reference NEC

Article 680.26).

11. Pour concrete and nish the pool deck surface.

12. Once the concrete has cured, install the lift by aligning the holes

in the lifts base with the anchors installed in the deck. Secure

the lift to the deck using the stainless steel hardware provided.

Be sure to use anti-seize on all hardware.

FIGURE 6

Revised 11/20/14

V.1.1