Aqua Creek Products F-EZPL2-02 Manuel - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aqua Creek Products F-EZPL2-02. Aqua Creek Products F-EZPL2-02 11 pages. Pool lift and hard seat option
TOOLS REQUIRED:
9/16" WRENCH
The EZ Pool Lift arrives with the boom arm attached to the mast. To
complete the assembly, layout all parts on a large, clean area.
1. Locate the hydraulic ram and attach the upper end of the hydraulic
ram to the boom with one (1) 3/8" x 1-3/4" hex head bolt, two (2) 3/8"
fl at washers and one (1) 3/8" nylock nut. See Step 1.
2. Connect the lower end of the hydraulic ram to the mast with one
(1) 3/8" x 1-3/4" hex head bolt, two (2) 3/8" fl at washers and one (1)
3/8" nylock nut. See Step 2.
WARNING!! MAKE SURE THAT THE 3/8" ROD END IS ALWAYS FULLY
SEATED WITH THE MAXIMUM ALLOWABLE THREAD BEING USED.
3. Install lift into previously installed anchor socket in the pool deck.
Make sure that the mast is seated at the bottom of the anchor. Check
to ensure easy rotation of the lift in nylon lined anchor sleeve.
4. Locate the chain assembly and insert the quick links
into the holes in the sling support bars (A).
Attach the hanger to the boom eye on the lift (B).
Adjust the chain links so that the sling is at the appropriate height to
allow the user easy access (C). This may require several adjustments.
Also, be mindful of any obstacles such as coping or a gutter that will
need to be cleared. See Step 4.
Assembly is complete. Prior to lifting any persons, it is recommended
that the lift be operated 3-5 times without a load for the lifts "break
in" period as well as to check for proper functioning (and that the
instructions for operating the lift be read and incorporated into a
training program for the persons who will be operating the lift).
For any person operating the lift, please continue to operating
instructions. Read carefully for comprehension.
Copyright © 2019 Aqua Creek Products All Rights Reserved
Assembly Instructions
3/4" WRENCH
3/8" NYLOCK NUT
STEP 1
BOOM ARM
3/8" FLAT
WASHER (2)
3/8" X 1 3/4"
HEX BOLT
MAST
STEP 2
MAST
3/8" NYLOCK
NUT
3/8" FLAT
WASHER (2)
3/8" X 1 3/4"
HEX BOLT
STEP 4
Revised 11/1/19
ACTUATOR
ACTUATOR
B
C
A
6