Aqua Creek Products F-RNGR2-02 Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aqua Creek Products F-RNGR2-02. Aqua Creek Products F-RNGR2-02 16 pages. Pool lift

Imprimer la page

FIGURE A

2. Mark out a section of the pool deck that you are removing. Plan on removing at least

4 feet 0 inches by 4 feet 0 inches.

3. Cut along your marks with a diamond blade

concrete saw.

4. Using the sledge hammer break up the concrete

within the cut area and remove the pieces.

5. Install rebar in the open area of the deck. Tie the

rebar into the existing deck if possible.

6. Set the anchor system in place. For ADA compliance

and clearance, make sure the center of the large

anchor jig plate hole is between 14.5 and 19 inches

from the pool's edge.

7. Using the string line or a straight edge, confi rm the top of each anchor body is level with the

FINISHED deck surface. Each anchor body can be individually adjusted by turning the nuts with a

large wrench.

8. Bond the anchoring system according to your local code requirements by using the bonding

lug on the anchor plate.

9. Pour concrete and fi nish the pool deck surface.

10. Once the concrete has cured, the lift is ready to be mounted to the anchoring system.

Anchor Installation: Saw-Cut Retro-Fit

You Will Need:

• Concrete saw with diamond blade

• Tape measure

Bonding Lug

• 4' long straight edge or chalk line

• Sledge hammer

• Cold chisel

1. Remove 1 nut from each anchor insert. Place the anchor

inserts through the larger hole of the anchor jig plate.

Thread the removed nuts back onto the anchor inserts. The

anchor plate should be sandwiched between the two nuts

on each anchor insert.

SEE FIGURE B

SEE FIGURE C, PAGE 8

SEE FIGURE C, PAGE 8 (See NEC Article 680.26)

SEE FIGURE A

• Torpedo level

• String Line

• Concrete & concrete

fi nishing tools

• #5 rebar

FIGURE B

Revised 6/17/19