AVM EVOLUTION MP 5.2 Manuel d'utilisation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} AVM EVOLUTION MP 5.2. AVM EVOLUTION MP 5.2 20 pages.
Imprimer la page16 Analogue output right (balanced, XLR)
17 Analogue outputs (RCA)
18 Analogue output left (balanced, XLR)
19 Digital output optical
20 Digital output coaxial
21 USB B digital input
22 Digital inputs optical
23 Configuration port (Updates)
24 Digital inputs coaxial
Installation and cooling
The unit can become warm depending on environmental temperature. Therefore it is important, that
the cooling air can flow unhindered into the air inlet in the bottom and flow out through the holes in the
rear panel. Direct exposure to sunlight is not recommended because this will heat up the unit and may
cause unwanted malfuctions.
Connection to mains
Connect the unit to the mains outlet by using the power cord which is (in some countries) delivered
together with the unit. Make sure that mains voltage is according to the value printed on the rear panel
of the amp (near mains connector).
CAUTION: Keep the unit switched off until all audio connections are made.
Connection to a preamplifier or integrated amplifier
Connect the analogue outputs (16,17,18) to the high level inputs of a preamplifier or integrated
amplifier.
The RCA-cinch outputs and the balanced XLR outputs are fully decoupled from each other and can be
used independently.
Connection of digital sources
Digital sources
Connect the outputs of your digital sources to the corresponding inputs of your Media Player:
- Optical inputs (22)
- Coaxial inputs (24)
- USB B input (21)
- AES/EBU input (26)
Digital out
The input of a digital recorder must be connected to the digital outputs (19, 20). The signal on the
digital outputs depends on the selected source (built-in CD, digital input).
RC 9 remote control
The optionally available RC 9 remote control allows for easy and comprehensive control of your
devices. Before you can use the RC 9 together with your device, both components need to be
connected. This process is also referred to as Pairing. In order to start the pairing process, please
follow the instructions as described in section 0.
25 Connector for external IR receiver
26 Digital input AES/EBU
27 Trigger outputs
28 Network connection (LAN)
29 USB digital input for storage media
30 WLAN antenna connection
31 Status LED
32 Update and reset button
33 Mains connector
34 Mains switch
7