AVM inspiration C6m Manuel d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} AVM inspiration C6m. AVM inspiration C6m 16 pages.

3. Basic operation

In case the C6m was not connected to mains a self test will be performed when it is switched on by mains

switch (30) for the first time. The unit checks it's configuration and if all installed components work properly. If

a DAB-Tuner is installed, the unit will scan the DAB band in order to indentify the available DAB stations.

This will last about 1 minute. The procedure is shown in the display.

Using the button power (1) You can switch between on (operate) and stand by. In the on state the display (3)

and the LED (2) light up. In stand by mode the display (3) is off and the LED glows to indicate that the unit is

still connected to mains.

CAUTION: When switched to stand by the unit is still connected to mains. In case of thunderstorm or if You

leave the house for a longer time we recommend that You switch the amplifier off by using the mains switch

(30) or pull the mains plug.

Use the source selectors (10 - 13) to select a signal source. The selected source is indicated in the display

(3).

Use the rotary encoder (14) to set the desired volume. Depending on rotating speed the volume increases /

decreases in 0,5 dB steps (slow) or 3 dB steps (fast). The actual setting is shown in the display (3).

The level of signal sources differs often by several dB. So You recognize a step in volume, when switching

between two inputs. It is also possible, that a source which is too loud overdrives the input and causes

distortion. With the sensitivity setting menu You can avoid this. The sensitivity of each input can be set

between – 12.5 dB and + 12.5 dB.

NOTE: The input levels of internal CD player, digital inputs and tuner are already set to equal values and

cannot be changed.

Select an input with the input selector (16) and chose a convenient volume level. Now press the button

MENU (under the display) for more than 2 seconds. The display (3) now shows "level". In the upper line it

shows the name of the actual source and on the right side the actual input sensitivity (factory setting: "0,0").

Set the sensitivity using the buttons

VALUE (7, 8). Switching between the several sources allows You to

compare and adjust the levels. If You are ready, press EXIT (5) and Your settings are stored.