Aqua Creek Products F-044SCH Manuel d'instructions - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Aqua Creek Products F-044SCH. Aqua Creek Products F-044SCH 16 pages. 24v solar charger
Imprimer la page
PRO POOL-XR
REMOVE 1/2"
HEX BOLT
To install the Solar Charger on a Pro Pool-XR lift;
STEP 1: Remove the 1/2" hex bolt from the back anchor insert as shown above.
STEP 2: Place the 24V Solar Charger over the base frame where the bolt was removed.
STEP 3: Align the mounting stud with the base frame & anchor insert. Thread the mounting stud into the
anchor insert and tighten. Use a 1" wrench to make sure it is snug.
STEP 4: Run the BATTERY CABLE along the base frame, back under the main frame, and up the actuator
frame as shown. The battery cable runs behind the CONTROL BOX, and the CONNECTOR will plug into
the control box (see INSTALLING THE CHARGE CONNECTOR).
4
Copyright © 2017 Aqua Creek Products All Rights Reserved
Pro Pool-XR Installation
NOTE: MAKE SURE TO RUN
BATTERY CABLE ALONG
BASE AND MAIN FRAMES
& UP ACTUATOR FRAME
AS SHOWN SO CABLE GOES
UP & DOWN WITH THE LIFT.
1/2" FLAT
WASHER
BASE FRAME
BATTERY CABLE RUNS
ALONG BASE FRAME,
BACK UNDER MAIN FRAME
& UP THE ACTUATOR FRAME
MAIN FRAME
BATTERY
ACTUATOR
FRAME
CONTROL
BOX
CHARGE
CONNECTOR
PLUGS INTO
CONTROL BOX
THREAD INTO
ANCHOR INSERT
& TIGHTEN WITH
1" WRENCH
Revised 12/4/17