AVM EVOLUTION C 5.2 Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} AVM EVOLUTION C 5.2. AVM EVOLUTION C 5.2 15 pages.

13 Antenna socket

14 Ground socket for turntable chassis

15 Speaker terminal B

16 Phono input

17 High-level analogue input 1

18 High-level analogue input 2

19 High-level analogue input 3

20 Output for recorder (fixed level)

21 Preamplifier output

1.3 Installation and cooling

The unit can become hot depending on demanded output power / environmental temperature.

Therefore it is important, that the cooling air can flow unhindered into the air inlet in the bottom and

flow out through the holes in the rear panel. Direct exposure to sunlight is not recommended because

this will heat up the unit.

Connect the unit to the mains connector (30) by using the power cord which is (in some countries)

delivered together with the unit. Make sure that mains voltage is according to the value printed on the

rear panel of the amp (near mains connector).

CAUTION: Keep the unit switched off until all audio connections are made.

High-level sources

Connect the outputs of your signal sources to the inputs (17-19). The upper row is for left channel, the

lower row is for right channel.

Turntable

Connect the output of your turntable with phono inputs (16) and connect the chassis ground wire to

the ground connector (14). The C 5.2 phono input is suitable for MM cartridges as well as for high and

medium level MC cartridges. Sensitivity can be adjusted (see 2.4.1)

Inputs SPDIF/ (RCA cinch, optical)

Connect the outputs of your digital sources to the corresponding inputs of the C 5.2 (24, 25).

22 Configuration port

23 Connector for external infrared sensor

24 Digital input coaxial

25 Digital input optical

26 Digital output coaxial

27 Digital output optical

28 Speaker terminal A

29 Mains switch

30 Mains connector