AVM EVOLUTION CS 5.2 Manuel d'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} AVM EVOLUTION CS 5.2. AVM EVOLUTION CS 5.2 20 pages. Compact streaming cd-receiver
Imprimer la page15 Antenna socket
16 Ground socket for turntable chassis
17 Network connection
18 Phono input
19 High-level analogue inputs
20 Status LED
21 Update button
22 Reset button
23 USB digital input
24 WLAN antenna connection
1.3 Installation and cooling
The unit can become hot depending on demanded output power / environmental temperature.
Therefore it is important, that the cooling air can flow unhinderedly into the air inlet in the bottom and
flow out through the holes in the rear panel. Direct exposure to sunlight is not recommended because
this will heat up the unit
1.4 Connection to mains
Connect the unit to the mains outlet by using the power cord which is (in some countries) delivered
together with the unit. Make sure that mains voltage is according to the value printed on the rear panel
of the amp (near mains connector).
CAUTION: Let the unit be switched off until all audio connections are made.
1.5 Connecting analogue signal sources
High-level sources
Connect the outputs of Your signal sources to the inputs (19). The upper row is for left channel, the
lower row is for right channel.
Turntable
Connect the output of Your turntable with phono inputs (18) and connect the chassis ground wire to
the ground connector (16). The CS 2.2 phono input is suitable for MM cartridges as well as for high and
medium level MC cartridges. Sensitivity can be adjusted (see 2.3.1).
1.6 Connecting digital signal sources
Inputs SPDIF/ (RCA Cinch, optical)
Connect the outputs of your digital sources to the corresponding inputs of the CS 2.2 (29, 30).
Digital out
The input of a digital recorder must be connected to the output digital outputs (31, 32). The signal on
the digital outputs depends the selected source (build in CD, dig in).
1.7 Network connection (LAN, WLAN)
In order to make use of the streaming- and network functions the CS 2.2 needs tob e connected with a
local area network (LAN). You have the choice between a LAN cable connection or a wireless WLAN
connection (see 1.13). Please note that the WLAN connection is deactivated as soon as the LAN
connection is operating (see 4.5.1).
25 Output for recorder (fixed level)
26 Preamplifier output
27 USB configuration port
28 Speaker terminals
29 Digital input coaxial
30 Digital input optical
31 Digital output coaxial
32 Digital output optical
33 Mains switch
34 Mains connector