AvMap FarmNavigator All in One RTK Manuel d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AvMap FarmNavigator All in One RTK. AvMap FarmNavigator All in One RTK 5 pages.

Imprimer la page
3. How to use the receiver with Farmnavigator products
Connect the power cable to the Farmnavigator's "GPS Antenna" connector and you are ready
to use your receiver.
Follow the instructions available in the Farmnavigator's user manual in order to check the
satellite signals on your G7 Farmnavigator.
3.1 G7 Farmnavigator series connection scheme
Generic Device
3.2 G6 Farmnavigator* connection scheme
3 Pole plug
Power
Receiver
Power cable
4
Controller
Receiver
GPS Antenna
Power cable
*Compatible only with Turtle Smart
4. How to use the receiver with third-party devices
The receiver can be used with any third-party device compatible with serial communication and
NMEA 0183 messaging (RS232 protocol).
4.1 Third-party devices connection scheme
To connect the receiver to a third-party device, simply connect your device to the DB9 connector
end of the power cable according to the Pin-Out presented below.
PIN n°
2
3
4
5
4.2 NMEA Baud rate
Farmnavigator GNSS receivers can output standard NMEA messages at different baud rates.
The default setting is at 115200 bps which is the most commonly used by third party displays.
For any other specific setup, please refer to your distributor/reseller or to www.farmnavigator.com.
6
1
9
5
Third-party
device
PIN-OUT
Function
GPS TX
GPS RX
GPS VCC
GPS GND
5