Aqua EZ APC493 Manuel d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Aqua EZ APC493. Aqua EZ APC493 6 pages.

Imprimer la page

Trouble Shooting Guide

PROBLEM

Cleaner does not move

or moves slowly

Cleaner does not cover

entire pool

Cleaner does not climb

Cleaner spends too

much time on the walls,

and/or climbs out of

the water.

Cleaner sticks in

corners under ladders

or on pool steps.

Cleaner stays in only

one end of the pool.

Cleaner falls on its side

Additional parts and technical support are available at [email protected] or call directly

1-877-852-4264 Mon – Thurs 8AM-5PM or Friday 8AM-3PM EST

Note: In water 60° F (16° C) or less, it may be necessary to increase flow to compensate

for the reduced flexibility of the hose and diaphragm.

• Use Suction test gauge at end of hose to make sure the suction is sufficient.

• Adjust Flow Regulator #7, to increase flow to cleaner.

• Clean pool skimmer basket and filter.

• Check diaphragm for damage or wear. Replace if cracked or damaged.

• If the pool has multiple skimmers, verify that the skimmer not connected to the cleaner

is closed. Close skimmer that is not in use.

• Check for air in system. If water level in pump basket drops or you see excessive air

bubbles in the pump basket or coming from the return lines, there is air in the system.

Check hose connections, remove any air in vacuum hose and tighten all fittings at pump.

• If the pool has a main drain, close drain using valve until proper suction is achieved.

• Adjust Flow Regulator #7, to increase suction to cleaner.

•

Ensure that the correct amount of hose is installed. Try adding or taking away

one or two hose lengths.

• Ensure that all the returns are directing water flow towards the floor of the pool, adjusting

the eyeballs, or using water diverters available at your local pool shop.

• Make sure hose is not kinked or coiled. Lay in sun to straighten if necessary.

• Confirm proper hose length.

Note: EZ-Vac wall climbing ability may be limited in some pools.

• Ensure the pool water is properly balanced. For example, High pH and/or lack of chlorine,

makes the walls very slippery

• Increase the suction using the flow regulator.

• Check balance of cleaner to make sure hose weights are in the correct position

• Decrease the suction using the flow regulator.

• Adjust the hose weight provided towards the cleaner head.

• Adjust Flow Regulator #7, to decrease suction to cleaner.

•

Ensure that the correct amount of hose is installed. Try adding or taking away

one or two hose lengths.

• Ensure that all the returns are directing water flow towards the floor of the pool,

adjusting the eyeballs, or using water diverters available at your local pool shop.

• Make sure hose is not kinked or coiled. Lay in sun to straighten if necessary.

• Confirm proper hose length and suction - adjust as necessary.

•

Ensure that the correct amount of hose is installed. Try adding or taking away

one or two hose lengths.

• Ensure that all the returns are directing water flow towards the floor of the pool, adjusting

the eyeballs, or using water diverters available at your local pool shop.

• Make sure hose is not kinked or coiled. Lay in sun to straighten if necessary.

• Confirm proper hose length.

• Adjust the hose weight provided towards the cleaner head.

• Adjust Flow Regulator #7, to increase suction to cleaner

• Make sure that the vacuum swivels freely where it is connected to the hose.

POSSIBLE SOLUTIONS