Avnet ROHM Semiconductor Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avnet ROHM Semiconductor. Avnet ROHM Semiconductor 8 pages. Power module
Imprimer la page
Along with meeting these geometry requirements, headers J1, J2, and J3 are placed on the
bottom of the board according to the definition below:
These locations are based on a topside view looking through the board. The headers are
placed on the bottom. J3 is measured to the center of the connector. The mounting holes are
plated through holes with a 125mil diameter. The mounting holes are not electrically connected
on the module.
Pin 1 locations for J1, J2 and J3 are illustrated below in Figure 2. The view is looking down on
the board with the connectors facing up.
Copyright © 2012 Avnet, Inc. AVNET and the AV logo are registered trademarks of Avnet, Inc. All other brands are property of their respective owners.
Avnet Electronics Marketing
Max Board Width
Max Board Length
Clearance Between Mated Boards
(power module and baseboard)
Figure 1 – Mechanical Header and Mounting Hole Locations
Table 5
7 of 8
3.5"
5.5"
0.45"
Rev A 1.0
06/05/2013