Aqua Flo AQUV-20 Manuel du propriétaire - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Aqua Flo AQUV-20. Aqua Flo AQUV-20 16 pages. Ultraviolet disinfection system

Imprimer la page

"A3" – LAMP EXPIRY: If the display shows "A3" alarm with red LED on and ballast beeps every 5 seconds, it indicates that the lamp has

expired. Do not consume water until lamp is replaced.

You can silence the alarm for 7 days by pressing and holding the button until "dELy" is displayed. You can silence the alarm 3 times

after which the alarm will not silence until you replace the UV lamp.

RESETTING THE LAMP EXPIRY TIMER: After replacing the UV lamp annually, you must re-set the ballast timer to clear the "A3"

alarm. To do this press and hold the button for approx 10 seconds until "rSET" is displayed. Release button and the ballast will emit a

long beep to confirm reset. Green LED will come on and red LED will turn OFF. Display will show "365" again.

(G) OPERATION AND MAINTENANCE

Your UV system is ON continuously during normal use and will continuously supply safe water. (Note: Do not try to shut it off during short periods of

non-use as repeated ON/OFF cycles can shorten the UV lamp and ballast life). Failure to follow disinfection procedure if the system is shut off could

result in micro-biologically unsafe water leading to potential illness or death.

To maintain the optimum disinfection performance of the UV system:

UV lamp should be replaced when the display reaches "0". At this point, the UV lamp continues to light but its ability to disinfect the water drops

below safe limits. Therefore the UV lamp MUST BE REPLACED WHEN THE LAMP REPLACEMENT ALARM "A3" COMES ON.

The quartz dome should be cleaned at the time of lamp replacement. If the water quality parameters listed in section 'C' are exceeded, you

should clean and inspect the quartz dome more frequently and clean as necessary.

Replace pre-filters every 4-6 months.

ITEM

UV Lamp

Quartz Dome

O-Rings

Use only GENUINE AQUA FLO AQUV UV Lamps with your UV system. Aqua Flo UV lamps are designed

with extensive product research and engineering to provide reliable and consistent UV output and

performance that ensures the safety of your drinking water. Using non-Aqua Flo AQUV UV lamps can

not only compromise the system performance but also voids your product warranty, electrical and CSA

•

Unsafe drinking water which may lead to illness and/or death

Use of non-Aqua Flo AQUV lamps will void all warranty & product certification

Aqua Flo logo & lamp part #

REPLACEMENT FREQUENCY

Every 1 year of use

Every 3 years

Annually

USE ONLY GENUINE AQUA FLO AQUV LAMPS

certification, and may result in any one or more of the following issues:

Genuine Aqua Flo AQUV lamps can be identified as follows:

CLEANING

At least during every annual lamp change. More

frequently if water is hard or has iron, manganese etc.

WARNING

•

Ballast failure

N/A

•

Electrical fire

Blue ends