Avocent Cybex SwitchView Manuel d'installation rapide

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Avocent Cybex SwitchView. Avocent Cybex SwitchView 2 pages.

Imprimer la page
The following instructions will help you
install and use your SwitchView SC8
DVI switch.
Should you require further assistance, please
contact Avocent Technical Support.
1
Connecting your local peripherals to
the SwitchView SC8 DVI switch
Power down all servers that will be part of your
SwitchView SC8 DVI switching system. Locate
your PS/2 keyboard, DVI monitors and PS/2
mouse. Plug your DVI monitor cables into the
CONSOLE ports on the left side of the back
of your switch. Plug your PS/2 keyboard cable
and your PS/2 mouse cable into the keyboard
and mouse ports respectively.
Connecting your servers to the
2
SwitchView SC8 DVI switch
Locate your fi rst cable set consisting of two
PS/2 cables and one or two DVI cables. The
SwitchView SC8 DVI switching system has eight
port sets labeled A-H on the rear of the unit. Plug
one end of the two PS/2 cables (keyboard and
mouse) and one end of a DVI cable (monitors)
into the corresponding ports on your computer.
Plug the other ends into any available server port
set on your SwitchView SC8 DVI switching system.
Repeat this process until all servers are properly
attached to the SwitchView SC8 DVI switch.
To Contact Avocent Technical Support
Avocent, the Avocent logo, The Power of Being There, Cybex and SwitchView are registered trademarks of Avocent Corporation or its affi liates. ©2005 Avocent Corporation. All rights reserved.
Quick Installation Guide
®
Cybex
SwitchView
SC8 DVI Switch
To install the Cybex SwitchView SC8 DVI switch
CONSOLE
H
Power down all
connected servers.
3
peripherals to the
Power up
CONSOLE ports
your system.
Powering your system
3
Locate the power cord that came with your switch.
Plug one end into the IEC power connector on
the SwitchView SC8 DVI switch. Make sure that
the power switch is off, then plug the other end
of the power cord into an appropriate AC wall
outlet. Power up your switch fi rst, then power up all
attached servers.
CALL (888) 793-8763
VISIT www.avocent.com/support
The Power of Being There
G
F
E
D
1
Connect your
on the switch.
4
Switching your servers
Press the appropriate front panel button labeled
A-H to access another server in your SwitchView
switching system.
®
®
4
Press the
appropriate front
panel button
labeled A-H to
access servers in
your system.
C
B
A
2
Connect the eight
servers to the
switch with the
provided cables.
DOWNLOAD www.avocent.com
590-502-501A