Aqua FX Octopus RO/DI Manuel d'instruction et d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et d'utilisation pour {nom_de_la_catégorie} Aqua FX Octopus RO/DI. Aqua FX Octopus RO/DI 7 pages. 6 stage

Imprimer la page

These instructions cover the most common set up conﬁgurations. If you ordered different colored

tubing or ﬁlter cartridge housings, you may not be able to follow these instructions completely. All

AquaFX systems come with a 3 year limited warranty. Please contact us if you have questions

or problems with your unit. The Customer is responsible for ﬁlter and membrane changes and

associated costs. AquaFX carries a complete line of parts and accessories for all of our systems

www.aquariumwaterﬁlters.com

Octopus Microprocessor Controller Protocol:

As discussed in the above steps there are a few steps you will want to take before starting your

Octopus Reverse Osmosis Unit. Discussed below are the steps the microprocessor will take after

you have started to ﬁlter water. Allow for the system to pressurize, check for any leaks. After 10

seconds of the feed being turned on, plug the AC plug (power chord) into your 110v outlet. The

controller will be behaving as described below after the power is connected.

begin restricting the "T‟ ﬂow restrictor after the initial Membrane ﬂush to achieve your 80 psi, or

1:1 waste water ratio. (Whichever happens ﬁrst!)

1) a) Power on

pressure is present

b) If Source Light ﬂashes

too low or not present, Check that water supply is turned on.

c) When the Source Light is on

now the unit will automatically ﬂush itself for 30 seconds.

(This countdown is constantly monitored, such that if pressure is lost the Auto Flush will

stop) This is where you will begin to restrict the „T‟ ﬂow restrictor.

SYSTEM INSTALLATION.

2) a) Auto ﬂush ﬁnishes

pressure switches to assure pump can run safely.

b) Again if feed pressure is lost

c) If pressure is ok the Octopus will begin will produce clean water automatically.

3) When product line is full (via ﬂoat valve or external shut off valve) the Unit will light up

the "Full‟ light and begin to ﬂush the RO membrane again.

4) TDS Reading - The Octopus controller will display the wat er quality in parts per million

(ppm) in a 099ppm range. If the TDS exceeds 99ppm, the display will ﬂash 099P.

5) The "Octopus " controller will close the incoming solenoid until the High Pressure switch

has been a ctivated for 10 or more seconds. This is to eliminate any false triggering of

the shut off.

If at any time the feed pressure is cut, than the unit will blink the source light until positive fee d pressure is

reapplied.

or at 1877-256-3467, Thank you!

Unit will countdown for 10 seconds and make sure the feed

This is an indication that the feed pressure is either

"Aqua EE" Controller will check both „Low‟ and „High‟

This tells us that the feed pressure is ok, and

the Source Light will ﬂash .

You will want to

SEE STEP 7 ON