=============================================================================
=============================================================================
This release contains the following enhancements:
1. Added support to disable the local port OSCAR® graphical user interface (GUI) configuration
buttons (Setup, Commands, and Clear) via DSView 3 software.
Note: This feature requires DSView 3 software version 3.6 or later.
2. Added support for "auto-discovery" to enable the DSR switch to register itself with DSView 3
software as an "unmanaged" device.
Note: This feature requires DSView 3 software version 3.6 or later.
3. Optimized the DSR switch's video mode detection algorithm to detect the target device's video
mode and display remote video more quickly so the user can see the POST (Power-On Self Test)
and BIOS screens on faster booting computers.
4. Added support to dynamically enable and disable secure mode on a DSR switch from DSView 3
software. Previously, this required removing the switch from DSView 3 software and adding
again.
Note: This feature requires DSView 3 software version 3.6 or later.
5. Added support for the Avocent iKVM switch integrated into the Dell® PowerEdge® M1000e
Modular Blade Enclosure to provide seamless access to each of 16 server blades and the Dell
Chassis Management Controller (CMC).
Note: The iKVM switch may require a firmware update to support this functionality.
6. Updated the Onboard Web Interface (OBWI) help link to point to an online version of the user
manual.
=============================================================================
=============================================================================
This release contains the following fixes:
1. Resolved issue where target devices on an AutoView® switch cascaded via the RJ45 ACI ports
from a DSR switch could not be selected from DSView 3 software.
2. Resolved usability issues in the OSCAR GUI IP Setup screen to allow the user to leave the
gateway field blank to specify no default gateway.
3. The IP address fields on the serial setup console's network configuration menu are now hidden
when the IP configuration is set to "None."
4. Resolved issue where a DSR switch in IPv6 mode is removed from DSView 3 software; the switch
was left in secure mode preventing it from being discovered by another DSView 3 software
system.
5. Resolved issue on DSR8020 and DSR8030 switches where the local port user could not connect
to a target device if four (4) unshared remote KVM sessions were active.
Enhancements
Fixes
Imprimer la page