Aqua Lung Conshelf XIV Supreme Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aqua Lung Conshelf XIV Supreme. Aqua Lung Conshelf XIV Supreme 20 pages.
Imprimer la page
7
PREPARATION AND SET UP
Aqua Lung America, Inc. requires that only an Authorized Aqua Lung Technician
install any accessory items such as instrumentation, MP inflator hose, alternate
air source, DIN connector or FCD to the regulator.
Attaching the Yoke Connector to the Cylinder Valve
1. Partially loosen the yoke screw on the first stage regulator so that the dust
cap can be removed from the air inlet.
2. Remove the protector cap from the cylinder valve.
3. With the cylinder valve facing away from you, release a small amount of air
from the cylinder by turning the handwheel counter-clockwise to open the valve
only slightly. When air is heard exiting, immediately close the valve. This will
clear any moisture or debris that may be inside the cylinder valve outlet opening.
4. Check the condition of the cylinder valve o-ring.
5. Place the first stage regulator over the cylinder valve so that the inlet fitting
aligns with the o-ring of the cylinder valve and the MP hose of the primary
second stage will be routed over the right shoulder. While holding the first
stage in place, turn the yoke screw clockwise. Ensure that the yoke screw
mates into the small dimple on the backside of the cylinder valve and tighten
until finger tight (Fig. 2).
Figure 2