Avocet 45tt Manuel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Avocet 45tt. Avocet 45tt 13 pages.

Imprimer la page

2b. ROAD RECEIVER.

For standard

road forks. Position the receiver on the front

of the right fork blade opposite the transmit-

ter magnet (black stripe in illustration). The

side of the receiver with the wires coming out

of it should be next to the magnet. Thread a

cable tie through the hole in the receiver holder

and around the fork. Pull the cable tie tight.

Position the receiver so that it is as close as

possible to the transmitter by rotating the

holder on the fork and by sliding its toothed

adjuster in or out.

Tie

Receiver

3. RECEIVER WIRE.

Secure the wire

with ties or tape starting at the receiver. Attach

the wire only to parts that rotate when the bi-

cycle is steered–the fork, the handlebar stem,

or the front brake cable. Do not attach the wire

to the head tube. Wrap excess wire around the

front brake cable.

Cyclometer

Brake Cable

Tie

MOUNT BRACKET.

Remove the clamp

screw and place the mount bracket on the han-

dlebar near the right side of the stem. Insert

the clamp screw and tighten it until the bracket

does not move when the Cyclometer is inserted

or removed. If the handlebar is too small for

the clamp, put the shim provided under the

clamp for a tight fit.

MOUNTING THE UNIT.

Slide the Cy-

clometer into the mount bracket from front to

rear until it snaps on. Choose the speed func-

tion, then spin the front wheel and watch for a

reading. If the display remains at zero make

sure that the receiver and transmitter are

aligned and nearly touching.

INSTALLING A NEW BATTERY.

remove the battery, pry up the cap on the back

of the Cyclometer with a screwdriver. Install

the new battery with its positive (+) side to-

ward the cap, then press in the cap with your

thumb. Use only an Avocet Cyclometer 45 bat-

tery or equivalent (see specifications). Remov-

ing the battery erases setup data and total dis-

tance. After installing a battery, the unit goes

into setup ready for entry of setup data. At

this time total distance can be programmed

into the Cyclometer.