Aqua Medic SP 3000 Niveaumat Manuel d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Aqua Medic SP 3000 Niveaumat. Aqua Medic SP 3000 Niveaumat 18 pages.

Imprimer la page

Fig. 1: Installation method for dosing from a dispensing vessel.

1. Receiving vessel (Aquarium, sump etc.)

2. Niveaumat

3. Dispensing vessel (reservoir, etc.)

4. Level sensor

5. Suction fitting

6. Non-return valve

7. Power supply 12 V~

8. Inlet into the aquarium with drip counter

5. Connection to the aquarium

Level probe: At aquariums with an internal filter or a closed filter system (cannister filter), the

level sensor is placed directly in the aquarium. The swimmer has to be placed exactly at the

height of the desired water level. To fix the probe, it is mounted on the holding plate and fixed

with rubber suckers at the aquarium glass. Take care to fix it safely. To be sure, we

recommend to glue each rubber sucker with a drop of aquarium silicone on the glass plate. At

aquariums with open filter systems under the tank (e. g Aqua Medic Reef 500), the level probe

is fixed in the filter tank in the height of the desired water level (Fig. 2).

Suction fitting: The suction side of the pump (left connection) is connected to the suction

hose (4/6 mm) and to the storage vessel and connected to the suction fitting (5). Glass or

plastic tanks and cannisters with the right volume can be used as storage vessel. The suction

fitting is placed at the bottom of the storage vessel. The non-return valve will prevent water

flowing back down the pressure hose. In any case, the outlet should always be positioned

above the surface level of the receiving vessel. This prevents the storage tank syphoning out

should the pump stop with the drive axle in the horizontal position.