CP Electronics MWS3A-AT-PRM Manuel du produit - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} CP Electronics MWS3A-AT-PRM. CP Electronics MWS3A-AT-PRM 17 pages. Rd ceiling microwave presence detector-switching
Également pour CP Electronics MWS3A-AT-PRM : Manuel d'installation (20 pages)
Imprimer la page
Basic programming
The functionality of the MWS3A-AT-PRM Sensor is
controlled by a number of parameters which can be
changed or programmed by any of the following devices:
UHS4 Infrared Handset
UNLCDHS Infrared Handset (with LCD)
Important note
Do not use as hub if the installation uses Area Codes. If Area Codes are used, make a non MWS3A-AT detector
or Slim-line controller a hub in the same local codes as the MWS3A-AT .
6
For most basic programming operations the UHS4 handset
is recommended and the following procedures are based
on using this device.
Point the handset at the Sensor and send the required
programming commands to the unit as shown in Steps 1, 2
and 3.
Valid commands will be indicated by a green LED flash.
See page 1 for details of other LED responses.