Billi B5000LMB Manuel de l'utilisateur - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Billi B5000LMB. Billi B5000LMB 16 pages.

User guide

Billi B-5000 – XL, XT, XR.

Filter removal and

replacement instructions

Important note: Please ensure you remove the

foam packing under the filter before installing .

1 . Remove the front panel .

2 . Place the unit in Holiday Mode by

pressing the Pressure Relief button once .

The lights on the dispenser will alternate

and then go off

3 . Hold filter and swing towards you slowly .

The top of the filter is in a hinged cradle

assembly . It should stop after approximately

30 degrees of travel .

4 . The filter can now be released from the

holding cradle by pulling down on the filter .

5 . Take care not to spill water in the base of the

tray . If so wipe gently with absorbent paper .

6 . Install new filter into the same location

by pushing all the way up into the cradle .

7 . Push filter back into the unit until it locks

into place . Power light should come back on .

8 . Flush chilled side until water flow stops .

Wait 10 minutes .

Repeat these steps 2 times .

9 . Check for any leaks from around the

filter, hosing or pipeworks .

10 . Replace the front cover .