Billi B-6000 Manuel d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Billi B-6000. Billi B-6000 4 pages. Boiling and chilled filtered water system
Également pour Billi B-6000 : Manuel de l'utilisateur (17 pages)

Imprimer la page

Installing the

dispenser.

IMPORTANT: Remove burrs and check internal

bore is completely smooth.

4. Fit dispenser head assembly

a. Lay dispenser head assembly alongside

mounting base assembly.

b. Feed dispenser tubing and loom through

centre hole in the following order:

i. Dispenser power cord.

ii. 5mm and 10mm black drain tubes

(water-cooled)

iii. Grey vent silicone tube. Feed tube

until reducing join passes through

mount assembly – see Diagram 8.

iv. Red and blue silicone tubing.

To assist feeding the tubing, we

recommend using silicone spray

lubricant. Do not attempt to force

tubing through with a pointed object

as silicone tube is easily punctured.

Check tubing is not kinked or twisted.

c. Turn dispenser head assembly to

approximately 60° from the straight

ahead position of dispenser base.

Slide head assembly onto base assembly

whilst gently pulling tubing downwards

from underneath to prevent tubing

bunching and kinking. Mounting lugs

will pass nut and slide down the

3 grooves on the swivel bearing.

d. Once fully down, turn dispenser to

straight ahead position. Fit chrome

plated M4 retaining screw to lower

rear threaded hole and tighten using the

allen key supplied. Check dispenser now

swivels smoothly 45° in each direction.

dispenser base

template

Locking Nut

Base Casting

Ensure burr is

remover & edge

is radiused

Barbed

Mounting

Shaft

Barb locking bush in position

Remove burrs after cutting and

ensure internal bore is smooth

Cut off

excess

thread

Silicone

tubing

Installing

underbench module.

1. Flush water supply

Flush water supply pipework before installing

the underbench unit by connecting 450mm

flexible braided hose to the supply tap and

running water into a bucket.

2. Install underbench unit

Take care to observe minimum clearances.

Diagram 4

Ensure there is adequate access to service

the unit.

3. Connect dispenser tubing

and electrical plug

Connect all tubing and electrical plug as shown.

Ensure correct orientation of dispenser power

plug before insertion. Trim tubes to correct

lengths using a sharp knife or plastic tube

cutter. Avoid leaving excess tubing which

will sag, trapping water. Fit spring clamps

supplied to retain silicone rubber tubing

to barbed fittings. 5mm black refrigeration

cooling tube is fitted to a compression nut

Diagram 5

type fitting. Refer to Diagram 10. Nut to be

finger tightened only.

IMPORTANT: Boiling outlet (red), vent tube

Swivel

Bearing

(grey) and 10mm black drain tube must not

be kinked and must be installed with a

Gasket

Continual fall.

4. Connect Drain Tube

a. Clip white john guest fitting into sliver

hose clamp.

b. Drill ½ inch hole (using drill bit provided)

Washer if

required

into drainage point (pipe).

c. Fit hose clamp to drainage pipe, ensuring

the while john guest fitting surrounds the

Diagram 6

hole drilled.

d. Take the drain hose connection provided

and connect the 3/8 hose into the

drain clamp.

e. Connect the 3/16 hose into the condenser

outlet on the unit.

Washer

5. Remove the filter packing from under the

filter canister

Diagram 7

Diagram 8