Allied Systems Long Reach BHA Series Manuel d'installation, de maintenance et d'entretien - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'installation, de maintenance et d'entretien pour {nom_de_la_catégorie} Allied Systems Long Reach BHA Series. Allied Systems Long Reach BHA Series 20 pages. Billet handler
1. Follow steps 1-5 under bolt-on hooks.
Attachment
Frame
Figure 4-6, Quick hook inspection
2. Raise the slide plate until the button clicks into place.
WARNING
The attachment could fall off the truck if the
quick hook is not properly installed.
Slide plate must click into place. If the slide
plate does not click into place because the
truck carriage prevents the slide plate from
being raised up high enough, install shims
between the attachment and the body of
the quick hooks.
4.6 Hydraulic Connections
1. Before connecting the truck hydraulic system to the
attachment, the system must be purged through the
filtration system. This will eliminate any contamina-
tion that might exist in the auxiliary hydraulic system
of the truck.
2. Purge the system by installing a jumper line and
operating each hydraulic function (clamp, rotate
and side shift, if equipped) in each direction for a
minimum of 30 seconds. (Figure 4-7)
Hoses should meet or exceed SAE100 RI Type AT,
with maximum working pressure of 3,000 psi for all
attachment functions.
14
Truck
Maximum
Mast
Clearance
3/32"
Slide
Button
Quick
Hook
To Truck
To Clamp
Figure 4-7, Jumper line setup
1. Locate the slot in the top cover plate of the attachment.
Remove the caps covering the relief valve ports and
attach customer supplied hydraulic hoses. (Figure
4-8).
Figure 4-8, Hydraulic Connection
2. Never operate the truck or attachment until hydraulics
are properly connected.
WARNING
Any alterations to the original attachment
may affect performance or safety and result
in loss of warranty.
Close
Line
Open
Line
45-053, REV. 5/18