ABACUS Pisces Dossier d'information - Page 13

Parcourez en ligne ou téléchargez le pdf Dossier d'information pour {nom_de_la_catégorie} ABACUS Pisces. ABACUS Pisces 17 pages. Adjustable height bath

ABACUS Pisces Dossier d'information
Tap & Waste Connection
Connect the taps using the flexible water pipes provided making sure they do not snag when the bath is
lifted. Trimming of the inner lower & outer upper panels may be required to fit the panels around the pipe.
The waste is pre-assembled. Connect the flexible pipe to the waste outlet. Fit the manifold to the floor and
connect as detailed.
Plumbing Manifold
Electrical Connection
The control unit is located in the centre of the underside of the bath. A prewired lead is supplied and this
should be run to the mains supply as per the pre-install connections. The handset should be plugged in the
control box as per FIG 3.
Ensure the lead retaining clip is refitted once the handset has been connected.
Panel Fixing
The bath shell comes complete with the outer panels fitted.
Outer Access Panel Fixing
The bath shell comes complete with the outer panels fitted. These should fit outside the inner skirts and
should not touch the skirts.
Note: If the panel and skirts touch, marking will occur.
Inner Skirt Fitting
Offer an end skirt into place and locate the retaining/spacer bolt (FIG 4) on the bottom of the end frame
and use this to retain the inner end skirt. Repeat with the other end skirt.
Offer up the side skirt and use the bayonet pins to locate into the end skirts (FIG 5)
Once in place adjust the retaining/spacer bolt to achieve a neat finish between the end skirt and the side
skirt. Repeat for the other side skirt.
Operate the unit up and down to ensure there is no snagging and the unit moves freely with no
interference.
WARNING
In the event of mains failure during use of the bath, back-up batteries will enable the bather to exit the
bath. Immediately after installation, it is vital that the bath be connected to a mains supply for at least 24
hours before initial use, to ensure the batteries are fully charged. Failure to observe this requirement could
result in the user not being able to exit the bath in the event of a mains failure.
Abacus Pisces 069/Info.P 04/14v1a
13