AVPro Edge AC-MX44/88-AUHD-HDBT Manuel de démarrage rapide
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} AVPro Edge AC-MX44/88-AUHD-HDBT. AVPro Edge AC-MX44/88-AUHD-HDBT 4 pages. 4x4 and 8x8 18gb p s 4k60 (4:4:4) hdmi matrix switchers
Imprimer la pageAC-MX44/88-AUHD-HDBT
4x4 and 8x8 18gb p s 4k60 (4:4:4) hdmi matrix switchers
Quick Start Guide
The AC-MX44/88-AUHD-HDBT is a true 4x4 HDMI/HDBaseT matrix switch. This unit includes 4/8 HDMI inputs, and 4/8
HDMI/HDBaseT output blocks. These output blocks include a HDBaseT and HDMI port, these ports are mirrored,
and both are active. This Matrix supports HDMI 2.0(a/b), HDCP 2.2, up to 4K video resolution, and up to 18 Gbps
bandwidth. We are able to pass 18Gbps through category cable by using the new HDBaseT technology we have
developed called "ICT", learn more about ICT below. This switch allows any source (Blu-ray, UHD Blu-ray, satellite
receiver, game consoles, PCs, etc ... ) to be shown on any of the connected displays. This matrix equalizes and
amplifies the output to ensure the HDMI signal can be transmitted through long HDMI cables without loss of
quality.
This quick start guide will be going through:
•
Initial Setup
•
Front pannel controls
•
EDID Management
•
Display IP Data
•
Quick Connect to the Web Interface
•
Troubleshooting
1. Connect the HDMI input sources (Blu-ray, Set Top Box, etc...) to the AC-MX44/88-AUHD-HDBT.
2. Connect the HDMI output devices (AVR, Display, DistributionAmplifier, Extender) to the AC-MX44/88-
AUHD-HDBT.
3. Power on the sources.
4.Connect the power supply into the AC-MX44/88-AUHD-HDBT.
5.Turn on output devices/displays.
6.Use the front panel controls, supplied IR remote or free PC software to control the switch
Front Panel Control:
Switching
: The AC-MX44/88-AUHD-HDBT can be switched from the front panel by selecting
the OUTPUT button first and then selecting the INPUT button:
1. Press the button (1 through 4) on the bottom row that corresponds with the OUTPUT
(Display, or Sink Device) you would like to send to a source.
2. Once pressed, the switch will illuminate the OUTPUT button that you have selected, along
with the INPUT row, indicating that it is ready for you to select the INPUT.
3. Select the desired INPUT