CPA AMBRA Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CPA AMBRA. CPA AMBRA 8 pages. Circulation water pump

MANTEINANCE MANUAL

The electrical installation must be performed by a qualified professional, in compliance with

the technical and safety regulations in force. This pump is not equipped with a thermal switch,

so it must be installed under a thermal relay and differential protection in compliance with the

technical and safety regulations in force. In order to prevent electric shocks in case of damage

to the electrical wiring, always connect the pump to the system ground. (fig. A)

ground connection

copper rod / bar placed in depth

Do not connect the pump with damp or wet cables. This pump is not self-priming, so do not run the

pump empty. If this happens by mistake, immediately disconnect the power supply, then wait for

the engine to cool and then fill it with clean water. (fig. B)

Do not cover the motor body with rags or similar, this could cause a fire. Before proceeding with

the installation, check that the moving parts rotate freely: insert a screwdriver into the recess of the

motor shaft on the side of the fan protection grid and try to rotate the blades (fig. C). If the

movement is difficult to strike gently with a hammer the screwdriver in order to unlock the rotation.

Tampering or modification of the same determine the immediate end of the validity of the

guarantee and can cause serious damage to the machine and to the user.

INSTALLATION

The pump must be installed in a well-ventilated and dry place, protected from bad weather

and exposure to temperatures above 40 ° C. The pump must be installed in compliance with

the EN 60335-2-41 electrical safety standard: any electrical appliance powered at 230 V must

be installed at a minimum distance of 3.5 m from the edge of the pool. The base of the pump

is equipped with holes to be anchored to the ground: fix the pump on a flat and solid surface

by adopting suitable bolts for use to avoid vibrations. The pump must be installed in a

horizontal position in order to allow the correct operation of the bearings. The pipes for

transporting water to and from the pump must be fastened without burdening the connection

points with the pump:

www.cpa-piscine.it

RECOMMENDATIONS AND WARNINGS

docking station

>75 cm

fixing by welding or screw

fig. A

fig. C

AMBRA

pag. 4 di 8

fig. B

Ver01– 2021-06-18