CPAT FLEX IRX1 Manuel d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CPAT FLEX IRX1. CPAT FLEX IRX1 13 pages.

Line 2: the IP address is displayed when there is no problem. When there is a problem,

several messages can be displayed:

• "NO IP ADDRESS": No ip address is assigned to the unit. Verify that the network

cable is plug into the Ethernet jack.

• "FTP ERROR": The IRX1 unit cannot transmit data to the Effigis FTP server. Make

sure that the unit have access to the internet. Note that the unit can acquire a valid

IP address, but if there is no routing to the internet, this message will be displayed.

5.3 Communication

The IRX1 uses an RJ-45 Ethernet (10/100 Mbits/sec) Cat 5 cable to connect to the network.

To power off the unit there are two modes Normal and Force shutdown, usually the user

should privilege the normal shutdown mode to avoid undesired flash memory corruption,

force shutdown should be use ONLY in case that the device is no more responding.

In normal running application user should press the button press the front panel push button

ON/OFF for 1 second then let the IRX1- ends up every process properly than a message will

follow on the front LCD then the device will turn off.

To force the IRX1- to power down when it's running, press in the ON/OFF button on the front

panel for 3 seconds. When the unit stops, you can release the button. As it was mention

previously this is not the ideal shutdown method.

Your IRX1 unit can be wiped clean with a damp cloth. Do not immerse the unit in water. Avoid

solvents and commercial cleaners.

The technician shall do periodic visual inspections on the RF connections to make sure that

there is nothing loose or broken. Both can affect the performance of the system. In case that

a replacement is required, please contact Effigis for more information.

CPAT FLEX (IRX1)

Operation Manual

effigis.com