CPE C114 Manuel - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CPE C114. CPE C114 19 pages. Portable pump
Imprimer la page
7.3 Programming
Note: The VFD is factory set for optimal operational efficiency. If you need to make changes please
contact our service department for assistance.
All parameters of the inverter can be accessed by means of the keypad for commissioning and diagnostics
and are listed in Table 2.
•
The keypad parameter list is sorted in ascending order in compliance with the "display code" (Pxxx).
•
In order to provide quick access, all parameters of the inverter are divided into different groups
according to their function.
•
Group 0 contains the configurable "Favourites". In the default setting these are the most common
parameters for the solution of typical applications.
•
Based on the hundreds digit of the display code (Pxxx) you can quickly see in which group the
parameter is to be found on the keypad.
Table 2: Keypad Parameter List
Parameter
P1xx
P2xx
P3xx
P4xx
P5xx
P6xx
P7xx
P8xx
Note: This table is provided for reference only. Please contact customer support before changing any
parameters.
CPE Systems Inc.
|
Group - Name
Description
Group 1 - Diagnostics
Diagnostic/display parameters for displaying device-internal process factors, current
actual values, and status messages.
Group 2 - Basic setting
Setting of the mains voltage, selection of the control and setpoint source, starting
and stopping performance, frequency limits, and ramp times.
Group 3 - Motor control
Configuration of the motor and motor control.
Group 4 - I/O setting
Function assignment and configuration of the inputs and outputs.
Group 5 - Network setting
Configuration of the network (if available).
Group 6 - Process controller
Configuration of the process controller.
Group 7 - Additional functions
Parameterizable additional functions.
Group 8 - Sequencer
The "sequencer" function serves to define a programmed sequence of speed
setpoints, PID setpoints or torque setpoints for the motor control. Switching to the
next setpoint can be executed in a time-based or event-based manner.
www.cpesystems.com
|
+1 800 668 2268
|
13