AVS RXPRO Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AVS RXPRO. AVS RXPRO 10 pages. 4-channel controller

Imprimer la page
REED SWITCH MODE ENABLE
If using wireless reed switches enable this mode. When the wireless reed switch sends "open" i.e. when your door or
window is opened, then the channel output will be latched on. When the door is closed the output turns off.
1.
Enter programming mode (see page 3)
2.
3.
4.
5.
LOW BATTERY OUTPUT FROM WIRELESS DEVICES
If this mode is enabled, if any wireless device programmed in to any channel sends a low battery signal then the
selected channel output will be activated.
1.
Enter programming mode (see page 3)
2.
3.
4.
5.
OR
Press button 3 repeatedly until the channels lights indicate the
output channel you wish to program.
The channel you select will activate whenever a low battery
signal is transmitted by any of the learnt in detectors.
Press button 2 repeatedly until the feature lights are on as
shown.
Press button 1 to swap the feature light(s) between flashing
and not flashing.
OR
Flashing
No output on low battery.
Press and hold button 2 on the remote control until the lights
start scrolling
Press button 3 repeatedly until the channels lights are on as
shown.
Press button 2 repeatedly until the feature lights indicate the
desired channel for reed operation.
Press button 1 to swap the feature light(s) between flashing
and not flashing.
Flashing
Reed Switch Mode disabled.
Press and hold button 2 on the remote control until the lights
start scrolling.
Reed mode has now been programmed.
Not Flashing
Reed Switch Mode enabled.
Not Flashing
Output on low battery.
Page 9