Allied Telesis CentreCOM GS980M/52 Manuel d'installation rapide - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Allied Telesis CentreCOM GS980M/52. Allied Telesis CentreCOM GS980M/52 20 pages. Gigabit ethernet switches
Imprimer la page
Installing the Switch
Installing the Switch on a Desk or Table
To install the switch on a desk or table, perform the following
procedure:
1. Place the switch upside down on a table.
2. Inset a rivet housing into a bumper foot.
3. Place the bumper foot on one of the corner holes in the bottom
panel of the switch.
4. Insert the rivet to secure the bumper foot to the base.
5. Repeat steps 2 to 4 to install the remaining bumper feet.
6. Turn the switch over.
7. Go to "Ports" on page 11.
Installing the Switch in an Equipment Rack
The following items are required to install the switch in an equipment
rack:
Two equipment rack brackets (included with the switch)
Eight M3x6mm bracket screws (included with the switch)
Cross-head screwdriver (not provided)
Four standard equipment rack screws (not provided)
To install the switch, perform the following procedure:
1. If the bumper feet are attached to the bottom of the switch,
remove them using a flat-head screwdriver.
2. Attach two brackets to the sides of the switch with eight M3x6mm
screws included with the unit.
the four possible positions of the brackets on the switch in a
standard 19-inch equipment rack.
CentreCOM GS980M Series Quick Installation Guide
The following figure
illustrates
7