Allied Telesis Rapier AR 700 Series Manuel d'installation rapide - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Allied Telesis Rapier AR 700 Series. Allied Telesis Rapier AR 700 Series 13 pages. How to set up pppoe between a linux client and access concentrator
Également pour Allied Telesis Rapier AR 700 Series : Comment configurer (6 pages), Manuel de dépannage (8 pages), Dépannage (5 pages), Comment faire (8 pages)
Imprimer la page
8
Change the password as soon as possible. Leaving the manager account with
the default password is a serious security risk. Make sure you remember the
new password as there is no way to retrieve it if it is lost.
Use the following command to change the account password:
set password
Use the following commands to save the configuration with the newly
created password, and set the router to use it on bootup:
create config=your-name.cfg
set config=your-name.cfg
To display a list of help topics, enter:
help
To display help on a specific topic, enter:
help topic
Alternatively, type a question mark (?) at the end of a partially completed
command to see a list of valid options.
See the AR Series Router Software Reference for more information on router
start-up and configuration procedures (including a list of message
definitions).
Using the GUI to configure a router:
This section describes how to establish a connection to the router through the
GUI, so you can configure the router before installing it in your LAN. For more
information about the GUI, see the AR700 Series User Guide.
1.
Select a PC to browse to the
You can browse to the router from any PC that is running a supported
operating system with a supported browser installed. JavaScript must be
enabled.
You need to know the PC's subnet.
2.
Connect the PC to the
Use an Ethernet cable to connect an Ethernet card on the PC to the eth0
port (see Figure 3).
You can browse to the router through any ETH port, as long as you give that interface
an IP address (see below). These instructions assume you will use eth0 as the LAN
interface.
router
from
router
AR700 Series Router
Software Release 2.6.1
C613-04027-01 REV E