Avsl 172.132UK Manuel de l'utilisateur - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avsl 172.132UK. Avsl 172.132UK 4 pages. Hybrid class-h power amplifier
Introduction
Thank you for choosing a Citronic H3200 power amplifier as part of your sound reinforcement system. These amplifiers use
hybrid class-H architecture to offer high power output in a compact, lightweight form factor. Please read this manual fully and
follow the instructions to achieve the best results from your amplifier and to avoid damage through misuse.
Warning
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on the casing, stop using immediately, allow unit to dry out and have checked by qualified personnel before
further use. Avoid impact, extreme pressure or heavy vibration to the case.
No user serviceable parts inside – Do not open the case – refer all servicing to qualified service personnel.
Safety
•
Check for correct mains voltage and condition of IEC lead before connecting to power outlet.
•
Ensure speaker leads are good condition with no shorted connections or damaged plugs.
•
Check that the impedance of speaker loads do not exceed the minimum stated load for the amplifier.
•
Do not allow any foreign objects to enter the case or through the ventilation grilles.
Placement
•
Keep out of direct sunlight and away from heat sources.
•
Keep away from damp or dusty environments.
•
When rack-mounting, ensure adequate support for the base of the amplifier and firm fixings for the front.
•
Ensure adequate airflow and do not cover cooling vents at the front and rear of the amplifier.
•
Ensure adequate access to controls and connections.
Cleaning
•
Use a soft cloth with a neutral detergent to clean the casing as required.
•
Use a vacuum cleaner to clear ventilation grilles of any dust or debris build-ups.
•
Do not use strong solvents for cleaning the unit.
Front Panel
1.
Cooling vent – do not cover or obstruct
2.
Channel 1 level
3.
Channel 1 indicator LEDs
4.
LCD status display
Rear Panel
8.
Mains fuse holder
9.
Channel 2 line input (XLR/jack)
10.
Mode switch - Parallel/Stereo/Bridge
11.
Input sensitivity switch 1.0V/1.4V/2.0V
12.
Channel 1 line input (XLR/jack)
13.
Channel 2 speaker output (SPK)
14.
Channel 1 (& Bridge) speaker output (SPK)
15.
IEC mains power inlet
5.
Channel 2 indicator LEDs
6.
Channel 2 level
7.
Power on/off switch
16.
Cooling vents – do not cover or obstruct
17.
Channel 2 line output (XLR)
18.
LF enhancer on/off switch
19.
Crossover 120Hz LPF on/off switch
20.
Channel 1 line output (XLR)
21.
Channel 2 speaker output (4mm posts)
22.
Channel 1 (& Bridge) speaker output (4mm posts)
172.132UK User Manual