Allied Telesis SWITCHBLADE 4000 Manuel d'installation rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Allied Telesis SWITCHBLADE 4000. Allied Telesis SWITCHBLADE 4000 8 pages. Switchblade 4000 series power supply unit
Également pour Allied Telesis SWITCHBLADE 4000 : Fiche technique (9 pages), Vue d'ensemble (1 pages), Comment configurer (9 pages), Manuel complémentaire (6 pages)
Imprimer la page
Quick Install Guide
C613-04028-01 REV B
5.
Remove the PSU bay faceplate or existing PSU
To remove a blank faceplate:
Loosen the faceplate's four Phillips mounting screws until they disengage
from the chassis, then remove the faceplate.
Keep the faceplate for future use. If you remove a PSU, replace the faceplate to prevent
dust and debris from entering the chassis and to maintain proper airflow.
The switch and PSU may overheat or be damaged by dust and debris if PSU
bays are left uncovered.
To remove an existing PSU:
Loosen the PSU's four Phillips screws until they disengage from the chassis.
Using the PSU's handle, pull the PSU out of the chassis.
6.
Insert the PSU
Slowly and carefully slide the PSU into the chassis (see Figure 2 on
page -5).
Firmly press the PSU home (until its front panel engages or nearly engages
the chassis).
Keep the PSU in a straight alignment and insert it slowly. Forcing a misaligned
PSU is likely to damage the chassis and PSU.
Figure 2: PSU insertion.
7.
Secure the PSU
Tighten the PSU's four Phillips screws.
8.
Apply AC power to the PSU (for AC models)
Plug the power cord into the PSU's AC power connector on the chassis's
rear panel (see Figure 3 on page -6). The connector for each PSU is the
connector that is directly behind the corresponding PSU bay.
5