Avsl 178.712UK Manuel de l'utilisateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avsl 178.712UK. Avsl 178.712UK 9 pages. Active speaker cabinets with dsp
Rear panel layout
Setting up
Position your CLARA active speaker cabinet(s) on a stable surface capable of supporting the load and
vibrations from the cabinet or ideally on a strong 35mmØ pole mount or speaker stand with an adequate safe
working load to support the cabinet. Also, each CLARA cabinet has M8 flying points for suspending from a
ceiling or truss if required. It is recommended to use 3 or more fixing points for suspension.
Aim the cabinet towards the audience or listeners and not in direct line of sight with any microphones that are
connected to the sound system to avoid feedback (howling or squealing caused by the mic "hearing" itself)
Each CLARA active speaker has an inbuilt Bluetooth receiver, which can be paired with a smart phone by
holding the Bluetooth on/off & pairing button (3) for 3 seconds. The blue status LED will flash to indicate
pairing mode. Search for "CLARA-12A", or "CLARA-15A" in the Bluetooth menu of the smart phone and select
to pair. Once paired, the LED will be lit constantly and the audio output from the smart phone will be
streamed wirelessly to the CLARA speaker. This input is governed by the LINE A input & Bluetooth level
control (9). Pressing the Bluetooth on/off pairing button briefly will switch the Bluetooth receiver on or off. If a
previously paired device is within range, the Bluetooth receiver will auto connect.
If a mixing console is being used to control input sources, connect the output of the mixer to the CLARA
cabinet LINE input (4) or MIC/LINE (6) with "LINE" selected on the MIC/LINE switch (10) using XLR or 6.3mm
jack connectors. If the system is in stereo, then usually one CLARA cabinet will serve the right-side output and
another for the left-side output. Normally, the volume of the CLARA cabinet LINE input is turned up high and
the output will be controlled at the mixer.
A microphone may also be connected directly to input A if the MIC/LINE switch (10) is in the "MIC" position.
If a playback device (e.g. mp3 or CD player) is to be connected directly to the CLARA cabinet, this is usually
connected to the LINE A input using a stereo to mono lead.
If the inputs to the CLARA speaker cabinet are to be linked onto a further active cabinet or amplifier, the mix
of all MIC/LINE/Bluetooth inputs can be fed from the MIX OUT line output XLR to further equipment (5)
When all necessary connections are made, finally connect the supplied IEC power cable (or equivalent) from
the mains power supply to the IEC power inlet on the CUBA speaker cabinet, ensuring that the supply voltage
is as indicated on the CUBA speaker unit (14)
1.
DSP display
2.
DSP USB port
3.
Bluetooth on/off/pairing button
4.
INPUT A line input XLR/Jack socket
5.
MIX OUT line output XLR
6.
INPUT B mic/line input XLR/Jack socket
7.
IEC power inlet and fuse holder
8.
DSP control rotary selector
9.
LINE A input & Bluetooth level control
10.
Input B MIC or LINE level switch
11.
MIC/LINE B input level control
12.
POWER on/off switch
CLARA active speaker cabinets User Manual