Avsl 178.812UK Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avsl 178.812UK. Avsl 178.812UK 8 pages. Performance pa with bluetooth

Imprimer la page

To listen to FM radio, press the MODE button repeatedly until the display shows "RADIO" and then the FM frequency.

There are 3 bands of FM memories – FM1, FM2, FM3, which can be selected in turn by a short press of the

Tune in available stations by holding the

Once fully scanned, the stored stations can be accessed via the

To connect a smart phone or other Bluetooth device to the DELTA-200 media player, press the MODE button repeatedly

until the display shows "BT" then "PHONE". Open the Bluetooth menu on your device and search for "PA SYSTEM

TSR12". Pair with this ID and connect in order to be able to play audio from the Bluetooth device to the DELTA-200.

During Bluetooth playback, pressing the

Pressing the

will pause or play the current track.

The EQ button can also apply the POP, ROCK or CLASSIC tonal profile or select "EQ OFF" for the unaffected option.

To play audio from the 3.5mm AUX IN jack, press the MODE button repeatedly until the display shows "AUX IN"

It is recommended to turn down all volume controls before powering down to avoid loud pops through the speaker.

Audio Recorder

To record the full mix of inputs that can be heard through the DELTA-200 speaker, insert a separate FAT32 formatted

USB pen drive into the USB REC port (5) and the recording LED will light to show that it is ready to record.

Press the "REC" button to start recording and the recording LED will flash whilst audio is recorded to the pen drive in

standard .wav audio format. Press the "REC button again to stop recording and the recorded track will be stored as a

.wav audio file named by numerical order (e.g. 001.wav)

Remote Control

In addition to the panel controls, an infra-red remote control is provided for the USB/SD player which adds some further

functions to allow greater control over the media player.

To operate, remove the clear plastic tab from the remote to activate the battery.

Charging the internal battery

When not in use but connected to the mains, if the POWER switch is in the

will be re-charged from the mains supply. This can be observed by the green battery status LEDs being lit.

Note: it is recommended to store the PA unit at an ambient temperature and not with the battery fully

discharged.

button for 3 seconds and releasing.





and

buttons will navigate tracks in the folder on the sending device.

Media player MODE select

Power On / Standby

Previous track or FM channel

FM tuner band (FM1, FM2, FM3)

Decrease volume

*not used*

Select track by number (first digit - second digit - third digit)

Direct access track number keys

Mute / Unmute

Play / Pause

Next track or FM channel

Repeat mode (RPT ONE, RPT ALL)

Increase volume

Select media USB or SD card

Enter track selection



and

buttons.

off

position, the internal battery

button.

178.812UK User Manual