Avtech avm420s Manuel rapide - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Avtech avm420s. Avtech avm420s 6 pages.

Imprimer la page

 Waterproof Accessories Installation

(Selected Model Only)

Step 1: Pass the network cable without connector through the

plastic tube cover as the right illustration.

Step 2: Put the waterproof seal into the plastic tube.

Step 3: Pass the network cable through the plastic tube and

screw it tightly.

 Focusing the Camera

If you need to adjust the focus, the picture shows you how to adjust.

Type A

 Camera Configuration

For advanced configuration of your camera, please be sure you have

connected your camera to NVR as shown below:

Step 4: Install a connector to the network cable.

Step 5: Put the O-Ring on the plastic tube as the left

illustration and connect the network cable with plastic

tube to the RJ45 waterproof connector of camera,

Step 6: Screw them tightly to prevent water seepage.

Type B

lens

for adjusting focal length

for adjusting focus

Step1: Connect PC to the HUB connected to your camera(s) with RJ45 network cable.

Step2: Search available devices with "IPScan.exe"; to download "IPScan.exe", please visit

www.surveillance-download.com/user/IPscan.zip

Step3: After searching, set your PC in the same network segment as the specific camera

you want to access, such as "192.168.30.xxx" (xxx could be 0~255) in our example

Step4: Note down the IP address and port number of the camera you want to access, such

as "192.168.30.1" and "88" in our example.

Step5: Open Internet Explorer on the PC, and enter the IP address and port number in

the URL column to access the camera. The format is http://ipaddress:portnum,

such as http://192.168.30.1:88 in our example.

 Preview the Viewing Angle with a BNC Monitor

(Selected Model Only)

This camera support composite output for you to

preview the viewing angle if it's correct or not

while installing camera. You need to open the

plate to find the receptacle housing of RCY

connector located next to the micro SD card

slot as the right illustration.

Please follow the specifications as below to

purchase the suitable plug.

 Specification of contact

15.8

1.8 2

1.7 2

 Overview of optional plug cable

Connect to a RCA cable

 Inserting MicroSD Card

The data originally saved in the microSD card (if any) will be removed after

inserting it to the camera.

The camera doesn't support hot-swapping. Please insert or remove the microSD

card with power disconnected.

Please follow the directions in the below graphic to insert MicroSD card properly:

Plug (Optional)

Receptacle housing

 Specification of housing

Receptacle housing (for pin contact)

Plug (for socket contact)

9.5

3.2

4.3